From: dale@sequent.com (Dale Mosby) Subject: DJ-580 HT review/info (long) I was asked about modification of the DJ-580 for out of band operation. They couldn't have made it much easier: - Remove battery pack. Use a small philips screwdriver (ie. jeweler size) to remove the 4 screws that hold the metal battery slide on the radio. These are at the outer corners of the metal clip. - Gently lift off the metal clip. Note that the two power wires are on this so don't pull it too far off. Also note that there is a small metal tab on this clip that is inserted in the battery release slide. You will want to insert it back in the same hole when you replace the metal clip. - You will see a small RED wire loop as well as a small BLUE wire loop. You can gently pull these up with some needle nose pliers. Cut the loops and then cover the ends so they don't contact anything. My method was to cut them not quite at the top, so one wire was a bit longer than the other. I then slipped a small piece of heat shrink tubing over the wires so the ends could not contact each other again. This is probably adequate. I took a CLEAN soldering iron and used that to shrink the tubing a bit just so it wouldn't move. - Push the wire loops back into the radio. The metal battery clip will push up against the circuit board running down the center of the radio so you don't want the wire loops crossing over the circuit board. - Replace the metal plate -- remember to stick the projection into the small hole on the battery release slide. - Replace the battery pack and reset the radio. You reset the radio by holding the function key down and turning on the power. Note that this clears all memories, so make the mod early -- this thing has 40 memory channels - a lot to reprogram. I cut both jumpers. Documentation I have, as well as verbal instructions was that the RED jumper opens up the out of band receive -- aircraft and cellular, while the BLUE wire opens up the out of band transmit. You certainly can't transmit in the aircraft or 800 band, I don't know just what transmit limits are, don't have any reason to stray outside of the ham band. Dale Mosby N7PEX