IC-2410A/H SPECIAL FUNCTIONS
 
MINI REPEATER FUNCTION (SUB BAND REMOTE CONTROL)
OPTIONAL UT-55 NEEDS TO BE INSTALLED  
 
OPERATION:  
1.   Set frequencies on both UHF and VHF.  If necessary set
     transmit offset and tone.  Then sub band remote control mode
     needs to be chosen.  
2.   Sub band remote control mode will be cancelled by sending D
     B * Remote control code and the set will go to mini repeater
     mode.  The identical function will be obtained which is
     described in #3 of "Mini Repeater Function".  
3.   Mini repeater function will be cancelled by the radio going
     to sub band remote control mode.  If pass word has been
     programmed, it is necessary to send a pass word.  Another
     way to cancel mini repeater function is to hold "SET" key on
     the main radio.  

OPERATION PROCEDURE:  
1.   Set frequency for both UHF and VHF.  If necessary, set
     transmit offset and tone.  
2.   Hold "BAND" switch and "SET" switch.  The memory number
     display will flash the letter "L".  This indicates the 2410
     is in the "Mini Repeater" mode.  
3.   Transmission by PTT is possible.  If PTT is operated, the
     band which is indicated by flashing decimal point will be
     transmitted.  This can be done even when in "MINI REPEAT"
     mode.  In other words, PTT has a priority over the "MINI
     REPEAT" operation.  
     Transmitted band will be switched by "UP" or "DN" key in the
     microphone.  The flashing decimal point will indicate which
     band will be transmitted.  
4.   Mini Repeater function will remain even when power is turned
     off.  To disable the repeater function, hold "SET" key until
     memory number display comes up.