==============================================================================
                             K E N W O O D
   >>>   A M A T E U R   R A D I O   S E R V I C E   B U L L E T I N   <<<
==============================================================================

                        Kenwood Service Centers

   Kenwood Service Corporation             Kenwood Service Center, East
   2201 East Dominguez Street              829 Lynnhaven Parkway, Suite 130
   Long Beach, California 90801            Virginia Beach, Virginia 23452
   Telephone 1-310-639-5300                Telephone 1-804-340-1702

==============================================================================

BULLETIN # 33
MODEL: RM-76
SUBJECT: CORRECTING THE FREQUENCY DIFFERERCE WITH THE RM-76 AND TR-7600
      

    The RM-76 will be about 500Hz higher in frequency than the
    TR-7600/TR-7625. This will not present any problem most of
    the time. Our specified tolerance is +750Hz. The operating
    frequency may be out of the receiver input of a repeater if the
    transceiver is turned slightly high, however. The frequency
    difference may be corrected by adding additional diodes in series
    with both the 02 and 52 lines in the RM-76. This is shown in the
    graphic.
    

    The foil paths from the connector to diodes Dl8 and Dl9 are cut
    and the new diodes soldered on the foil side of the board. The
    cathode end of the diodes is soldered to the connector side. We
    recommend using either 1S2076 or lSl555 dicdes.