==============================================================================
                             K E N W O O D
   >>>   A M A T E U R   R A D I O   S E R V I C E   B U L L E T I N   <<<
==============================================================================

                        Kenwood Service Centers

   Kenwood Service Corporation             Kenwood Service Center, East
   2201 East Dominguez Street              829 Lynnhaven Parkway, Suite 130
   Long Beach, California 90801            Virginia Beach, Virginia 23452
   Telephone 1-310-639-5300                Telephone 1-804-340-1702

==============================================================================

BULLETIN # 987
MODEL: TH-205/TH-215/TH-315/TH-415
SUBJECT: PTT KNOB INSTALLATION PROCEDURE

The original plastic knob (K29-3054-15) has been replaced with a rubber 
knob (K29-3054-35). The PTT mounting guide on the front panel must be 
removed to allow the new knob to be installed. The following procedure 
will explain the installation procedure.


1. Disconnect the battery pack and antenna.

2. Remove the four screws from the back panel. Figure 1

3. Carefully lift the front panel up and lay it to the right side of the 
   body of the transceiver.

4. Disconnect the front panel from the body of the transceiver.

5. The plastic PTT knob is held in place with three tabs. Press in the 
   bottom tab and then push the knob out of the front panel.

6. Push in the guide to crease it's two legs where they join the front 
   panel. FIGURE 2

7. Wiggle the guide back and forth until it breaks off the front panel. 
   Discard the guide and plastic knob.

8. Install the rubber knob on the front panel. The side with the square 
   tab goes toward the bottom of the front panel.