NEC P9000 (TR5E800-9A) NOTES: These are single or dual NAM units The ESN prefix is 135 decimal, 87 hex. NEC: 1-800-421-2141 1. This phone officially requires an NEC programing adaptor battery part number 41-2010, if you have one attach it and power up the phone. I you do not have the NEC adaptor one can be simulated by using a standard battery or cigarette lighter adaptor. Remove the battery from the phone and locate the small black round contacts in the battery compartment. The right hand contact must be grounded while powering up the phone. To do this use a long piece of solder wick, or other thin conductive material, lay it over the contact and carefully replace the battery. Then ground the solder wick to the antenna connector or - battery contact and power up the phone. If you have a cigarette lighter adaptor you can disassemble it and, by careful measurement, drill a hole to give you easier access to the test mode contact. 2. Having powered up the phone using one of the above methods press RCL # 0 1 to enter test mode. 3. (Dual NAM units only) Press RCL # 7 6 0 for NAM 1, or RCL # 7 6 1 for NAM 2. 4. Press RCL # 7 1 to enter programing mode. 5. The # key stores and increments each step. 6. At any time press and hold CLR to exit programing mode then press RCL # 0 2 to exit test mode. PROGRAMING DATA STEP# #OF DIGITS/RANGE DESCRIPTION 01 10 DIGITS MIN (AREA CODE & TEL#) 02 4 DIGITS LOCK CODE 03 00000 - 32767 SYSTEM ID 04 2 DIGITS GROUP ID (10 IN USA) 05 333 OR 334 INITIAL PAGING CHANNEL 06 0 OR 1 PREFERRED SYSTEM 07 2 DIGITS ACCESS OVERLOAD CLASS 08 0 OR 1 MIN MARK NOTE: To toggle between NAM 1 and 2 press FCN STO 3 with phone out of programing mode. LOCK: F * four digits = Partial lock, F # four digits = Full lock. Use same sequence to unlock. SYSTEM SELECT: F 5 then 5 to scroll.