Bearcat BC-205XLT

Expand Reception Range - 800 MHZ

Procedures:

1. Remove battery and antenna.
2. Remove 4 case attach screws. 2. from case and two from battery
   reating plate. Open case.
3. Locate and remove -2- screws at base of circuit board.
   Note how connector wires are attached.
4. Pull from panel from circuit.
5. Remove 10k resistor from location above letter "den" of
   microprocessor UC-1147.
6. Reassemble in reverse order.

Note: If unit fails to power up or recharge battery, the dual in-line
connector was installed incorrectly.