Each Gemini G3 is provided with 32 internally stored over-the-air programmable channels.
Use the table below to set up RX and TX frequencies for each channel .
Enter RX and TX frequency in MHz in the appropriate dialog box.
Entries in the RX column must fall within the Min RX and Max RX indicated on top of the page.
Entries in the TX column are computed as RX frequency plus the offset indicated on top of the page.
E.g.:
Assuming:
Min Rx=851.000 000 MHz
Max Rx=869.000 000 MHz
Offset=-45.000 000 Mhz
If selection for a channel's RX was:
Rx (MHz)=853.037 500
then its corresponding TX would be computed as:
Tx (MHz)=853.037 500+(-45.000 000)=808.037 500
"BW" entries for all channels can be :
"W" (Wide - 700MHz), "F" (Full - UHF or 800MHz), "H" (Half - UHF or 700MHz), or "N" (NPSPAC) - 800MHz) as appropriate.