Displays GeminiG3 software revision information retrieved from the connected unit.
Have this information handy if contacting Dataradio support.
The banner should read:
GeminiG3 E-DBA (Band) PROD Vx.y_Rxxx , where:
Product Name | GeminiG3 |
---|---|
Protocol Name | E-DBA |
Band(s) of Operation | 800 Mhz, 700 Mhz, UHF, etc |
Production Build | PROD Vx.y Rxxx where Vx.y is Major.minor version number, and Rxxx is Sequential Package Release Build Number |
Displays name of connected unit.
Configured under Setup Basic → General → Station Name
Displays System's unique identification number.
Configured under Setup Basic → General → System ID
24-hour clock format display of the GMT time and date adjusted to the specified time zone.
Configured under Setup Advanced → Time Source → SNTP and displayed as:
yyyy-mm-dd hh:mm:ss
Global position in Longitude (East-West) and Latitude (North-South) displayed using information obtained from a GeminiG3 unit decoding a valid GPS input signal.
If no previous position was obtained, display shows (Unknown).
Position are reported in degrees plus decimal minutes.
E.g. : Longitude of 73 degrees, 39 minutes and 45 seconds West would appear as:
073 39.7500 - W
Displays "Initializing" at startup, "Registered" in normal operation and "Roaming" while attempting to register to another base station.
Normally displays "Ok" in the message area.
Displays various warnings or messages in the event of hardware failure.
If indications persist, have the status information handy if contacting Dataradio support.
Press this button to clear the H/W Status message area.