Mitsubishi 129 (AH) - Programming
 
 MAN Type: EEPROM
 Manufacture: Mitsibishi
 Programmer: Keypad
 ESN Prefix:
         Decimal: 134
         Hex: 86
 ESN/Serial Number Match: No
 Channels: 832
 NAMS: 1
 Format: Analog
 Authentication: Yes
 
 Battery Must be fully charged before programming
  - NEVER POWER DOWN WHILE IN PROGRAM MODE -
 
 Programming Sequence:
 
 Power on
 
 Press and hold END
 Enter 6972814 (Within 10 sec. of power up)
 
 Release END
 Enter data for each step and press SEND
 For quick programming enter steps 1-3 only
 Press End to exit programming mode when finished
 
 STEP: 1
 Parameter: Mobile Number, 10 Digits
 Format: XXXXXXXXXX + SEND
 
 STEP: 2
 Parameter: System ID, 5 Digits
 Format: XXXXX + SEND
 
 Step: 3
 Parameter: Security Code, 4 Digits
 Format: XXXX + SEND
 
 Press END to Exit program mode
 Press SEND to return to step 1
 Press FCN to continue programming
 
 These are the defaults used in quick programming
 To change, enter new data + SEND
 To skip A-Key enter 0 + SEND
 To program A-key enter 1 + SEND
 Enter 6 to 26 digit Authentication number provided by carrier + SEND
 
 Paramater               Default setting
 Local Use               1 (Enabled)
 MIN Opt                 1 (Enabled)
 Initial Paging Channel  333 or 334 (Set by step 2)
 Access Overload         00
 Group ID                10
 Roam Inhibit            0(Disabled)
 SID Option              0(Disabled)
 A-Key                   0(Not Programmed)
 Emergency               911
 
 New Unlock Code: FCN + 92 + 4-Digit Security code + 3-Digit New unlock
 Code + STO
 
 System Select: FCN + 4 + (* or # to scroll) + END
 
 Pref A- AB
 Pref B- BA
 SYS Home- Home Only
 SYS A- A Only
 SYS B- B Only
 
 Display ESN:
 Power ON
 Press and hold END while entering 0944635
 Release END
 Press 18 + SEND (ESN Displayed)
 Press OFF to Exit
 
 IF Phone is accidently powered off during programming try this fix:
 Power ON for seven minutes
 power OFF
 Power on (Wait 2 SECONDS)
 Enter programming sequence
 Repeat if necessary