PRO-32 Portable Scanner/Receiver
(200-0133) Specifications Faxback Doc. # 16623
Frequency Coverage (VHF-Lo): .................. 30-50 MHz (in 5 kHz steps)
(Ham): ..................... 50-54 MHz (in 5 kHz steps)
(Aircraft): ............. 108-136 MHz (in 25 kHz steps)
(Government): ............ 138-144 MHz (in 5 kHz steps)
(Ham): ................... 144-148 MHz (in 5 kHz steps)
(VHF-Hi): ................ 148-174 MHz (in 5 kHz steps)
(Ham/Gov't.): ......... 380-450 MHz (in 12.5 kHz steps)
(UHF-Lo): ............. 450-470 MHz (in 12.5 kHz steps)
(UHF-Hi ["T"]): ....... 470-512 MHz (in 12.5 kHz steps)
Channels of Operation: ........ Any 200 channels in any band combinations.
(20 channels x 10 banks) and 10 Monitor channels.
Sensitivity (AM): .......... 20 dB Signal-to-Noise ratio at 60% modulation
108-136 MHz 2.0 uV
(FM): ......... 20 dB Signal-to-Noise ratio at 3 kHz deviation
30-54 MHz 0.6 uV
138-174 MHz 1.0 uV
380-512 MHz 1.0 uV
Spurious Rejection: ............................ 30-54 MHz 50 dB at 40 MHz
108-136 MHz 50 dB at 120 MHz
138-174 MHz 50 dB at 154 MHz
380-512 MHz Not Specified.
Selectivity: ............................................. +/- 9 kHz, 6 dB
+/- 15 kHz, 50 dB
IF Rejection: .................................. 10.7 MHz 50 dB at 154 MHz
Scanning Rate: ...................................... Fast 8 Channels/sec.
Slow 4 Channels/sec.
Search Rate: ........................................... Fast 8 Steps/sec.
Slow 4 Steps/sec.
Priority Sampling: ............................................. 2 Seconds
Delay Time: .................................................... 2 Seconds
Modulation Acceptance: ......................................... +/- 5 kHz
IF Frequencies: ..................................... 10.7 MHz and 455 kHz
Filters: .............................. 1 Crystal Filter, 1 Ceramic Filter
Squelch Sensitivity: .......................... Threshold Less than 1.0 uV
Tight (S + N)/N 15 dB
Antenna Impedance: ............................................... 50 Ohms
Audio Power: .............................................. 300 mW nominal
Built-In Speaker: .......................... 2" (5 cm) 8 Ohm, Dynamic Type
Power Requirements: ........ +9 VDC, 6 AA Batteries, or a suitable adapter
(negative ground only)
Current Drain: ......................................... 45 mA (Squelched)
160 mA (Full Volume Un-squelched)
3 Silver Oxide Batteries for Memory Back-up
Dimensions (HWD): ......................... 7-3/8 x 2-15/16 x 1-3/4 Inches
(187 x 74 x 45 mm)
Weight: ................................... 1.2 lbs (550 g) with batteries
Specifications are typical; individual units might vary. Specifications
are subject to change and improvement without notice.
(IR/eb 12/02/98)
Privacy Policy