DX-394 Communications Receiver
(200-0224)             Clock Radio Operation          Faxback Doc. # 31584

SETTING THE CLOCKS

Your receiver has two clocks.  We recommend you set the primary clock to
the local time and the secondary clock to UTC (Coordinated Universal Time,
also called Greenwich Mean Time).

NOTE:  The receiver's time display uses the 24-hour format.

1.  Press and hold down TIME SET for 2 seconds.  Time is selected and the
    time digits flash on the display.

2.  While the clock display flashes, use the number keys to enter the
    correct time.  For example, enter 930 for 9:30.

    NOTE:  If you make a mistake, press CLEAR to erase the last digit.

3.  Press TIME SET to select time.  The hour digit flashes.

4.  While the hour digit flashes, use the number keys to enter the hour
    for the second clock.

    NOTE:  You only need to enter the hour.  For example, enter 4 for 4:30.
           The minutes change automatically according to the primary clock
           setting.

5.  Press ENT to start both clock 1 and clock 2.  The colon flashes.

Press TIME SET to alternate between the time on clock 1 and clock 2.

USING THE TIMERS

Your receiver has five programmable timers.  You can store a tuning
frequency and on/off times into each timer.  When you turn on a timer, the
receiver automatically turns on and tunes to the programmed frequency when
the timer reaches the programmed time.  When it reaches the off time, the
receiver turns off.

NOTE:  The timers are set to Clock 1.

Programming a Timer

1.  Set the frequency that you want the receiver to tune to when it turns
    on.

    For example, set 12.345 MHz.

2.  Press TIMER.

3.  Within 10 seconds, enter the desired timer memory number (1 to 5).
    (For example, press 1 to select timer memory 1.)  The memory number
    flashes and the previously programmed frequency or 0.0000 appears.

4.  Press PGM to select the timer memory.  The band indicator and new
    frequency flash.

5.  To change the times, press TIMER.  The time digits flash on the
    display.

6.  Enter the time when you want the receiver to turn on.  For example,
    enter 15:30.

    NOTE:  If you want to set only the off time, press CLEAR.

7.  Press TIMER.  The time digits flash on the display.

8.  Enter the time when you want the receiver to turn off.  For example,
    enter 16:00.

    NOTE:  If you do not want to set the off time, press CLEAR.

9.  Press ENT to store the settings.

Turning on a Timer

1.  Press TIMER.

2.  Enter the timer memory number (for example, enter 1).  The selected
    memory number flashes.

3.  Press ENT.

4.  If you want to turn on more timers, repeat Steps 1-3.

5.  Press POWER to turn off the receiver.

Clearing a Timer

If the receiver is off.

1.  Press POWER to turn on the receiver.

2.  Press TIMER.

3.  Enter the timer memory number.

4.  Press CLEAR.

If the receiver has already turned on automatically, press POWER.  The
timer program is canceled and the receiver turns off.

USING THE SLEEP TIMER

The sleep timer sets the receiver to turn off after a set time (30 or 60
minutes) so you can fall asleep as you listen to the receiver.

Press SLEEP until the desired time appears - timer 30 or timer 60.

To turn off the receiver before it automatically turns off, press POWER.

To turn off the sleep timer, press SLEEP until the indicator disappears.


(EB 3/29/96)

Privacy Policy