6-in-1 Multi-Purpose Lantern
(610-2743)                 Power                      Faxback Doc. # 47959

POWERING THE LANTERN

Internal Batteries

You can power your lantern with six D batteries (not supplied).  We
recommend alkaline batteries such as RadioShack Cat. No. 23-550.

1.  Turn the battery compartment cover counterclockwise and remove the
    cover.

2.  Insert six D batteries as indicated by the polarity symbols (+ and -)
    marked inside the battery compartment.

3.  Replace the battery compartment cover by pushing down on it while
    turning clockwise.

CAUTIONS:  Use only fresh batteries of the required size and type.

           Do not mix old and new batteries.

           If the lantern will not be used for several days, remove the
           batteries.

           Never leave dead or weak batteries in the lantern.

           Dispose of batteries properly; do not bury or burn them.

Vehicle Battery Power

You can use the supplied power cord to power the lantern from your
vehicle's cigarette-lighter socket if your vehicle has a 12-volt DC,
negative-ground electrical system.

WARNING:  Be sure to turn off the lantern and disconnect the lantern from
          the cigarette-lighter socket before you change a bulb or the
          fluorescent light.

CAUTION:  Always connect the power cord to the lantern before you connect
          it to the cigarette-lighter socket.  Then disconnect the power
          cord from the cigarette-lighter socket before you disconnect it
          from the lantern.

(LB/eb 4/29/98)