Clip-On Antenna Mount 
(200-0023)                 Installation               Faxback Doc. # 47964

Your RadioShack Clip-On Antenna Mount is designed to let you temporarily 
mount your antenna (not supplied) on your vehicle's window.  Installing 
the mount is easy and requires no drilling.

Follow these steps to install Mount.

1.  Attach the antenna to the mount.

2.  Slide the mount's clip over the window with the antenna outside, then 
    carefully roll up the window.

    CAUTION:  Do not mount the antenna where it blocks the driver's view.

3.  Route the cable so it does not interfere with passengers or operation
    of the vehicle.

4.  Connect the cable to the antenna terminal on your radio.

To remove the antenna and mount, roll down the window and slide the clip
off of the glass.

Note:  This mount is not waterproof, and we do not recommend it for
       permanent installation.

(LB/eb 6/1/98)
(EB - Rev. 02/23/01)

Privacy Policy