Optimus Single Channel 170 MHz Wireless FM PA Amplifier System
(320-1240)                 Power                      Faxback Doc. # 56544

Connecting Power

You can power your amplifier with the supplied AC and DC power cords.

AC Power Cord

CAUTION:  You must use only the supplied AC power cord.  If you lose or
          damage this cord, order a replacement from your local RadioShack
          store.  Using other power cords could damage the amplifier.  Be
          sure amplifier POWER is set to OFF before you connect the power
          cord.  Always plug the power cord into the amplifier's 120V AC
          60 Hz jack first, and always unplug the power cord from the AC
          outlet first.

Set the amplifier to OFF.  Plug the power cord's small plug into the 
amplifier's 120V AC 60 Hz jack.  Then plug the other end of the cord into 
a standard AC outlet.

DC Power

CAUTION:  You must use the supplied DC power cord.  If you lose or damage
          this cord, order a replacement from your local RadioShack store.
          Using other power cords could damage the amplifier.  Be sure
          amplifier POWER is set to OFF before you connect the power cord.
          Always plug the power cord into the amplifier's DC 14.4V/2.5A
          jack first, and always unplug the power cord from the 12V
          accessory outlet first.

Make sure the amplifier is set to OFF and plug the power cord's barrel 
plug into the DC 14.4V/2.5A jack.  Then plug the other end of the cord 
into a standard DC source such as an automobile 12V accessory outlet.

(EB 9/1/99)