SCP-101 AM/FM Stereo Auto Reverse Cassette Player
(140-1253)                 Preparation                Faxback Doc. # 56575

Connecting Power

The SCP-101 operates form any of these power sources:

  internal batteries (not supplied).

  standard AC power (using an optional AC adapter).

  vehicle battery power (using an optional DC adapter).

Using Internal Batteries

Your SCP-101 requires two AA batteries (not supplied) for power.  For the 
best performance and longest life, we recommend RadioShack alkaline 
batteries.

CAUTIONS:  Use only fresh batteries of the required size and recommended
           type.

           Do not mix old and new batteries, different types of batteries
           (standard, alkaline, or rechargeable) or rechargeable batteries
           of different capacities.

Follow these steps to install batteries.

1.  Press and slide the battery compartment cover in the direction of the
    arrow until it stops.

2.  Lift the curved edge of the cover.

    CAUTION:  The battery compartment cover is hinged and cannot be
              removed.

3.  Place the batteries in the compartment and on top of the attached
    ribbon, as indicated by the polarity symbols (+ and -) marked on
    outside of the compartment.

4.  Close the cover.

When the sound gets distorted or weak, or the SCP-101 stops operating 
properly, replace the batteries.

WARNING:  Dispose of old batteries promptly and properly.  Do not burn or
          bury them.

CAUTION: If you do not plan to use the SCP-101 with batteries for a week
         or more, or if you plan to use only standard AC or vehicle power,
         remove the batteries.  Batteries can leak chemicals that can
         destroy electronic parts.

Using AC Power

You can power the SCP-101 using a 3V, 300-mA AC adapter and a size H 
Adaptaplug (neither supplied).  Both are available at your local Radio 
Shack store.

CAUTIONS:  You must use a Class 2 power source that supplies 3V DC and
           delivers at least 300 mA.  Its center tip must be set to
           positive and its plug must fit the SCP-101's DC 3V jack. Using
           an adapter that does not meet these specifications could damage
           the SCP-101 or the adapter.

           Always connect the AC adapter to the SCP-101 before you connect
           it to AC power. When you finish, disconnect the adapter from AC
           power before you disconnect it from the SCP-101.

Follow these steps to power the SCP-101 from standard AC power.

1.  If the adapter has a voltage switch, set the switch to 3V.

2.  Insert the Adaptaplug into the adapter's cord so it reads TIP +.

3.  Insert the Adaptaplug into the SCP-101's DC 3V jack.

4.  Plug the adapter into a standard AC outlet.

Note:  Connecting an adapter to the SCP-101's DC 3V jack disconnects the
       internal batteries.

Using Vehicle Battery Power

You can power the SCP-101 from a vehicle's 12V power source (such as 
cigarette-lighter socket) using a 3V, 300-mA DC adapter and a size H 
Adaptaplug (neither supplied).  Both are available at your local Radio 
Shack store.

CAUTIONS: You must use a power source that supplies 3V DC and delivers at
          least 300 mA.  Its center tip must be set to positive and its
          plug must fit the SCP-101's DC 3V jack.  Using an adapter that
          does not meet these specifications could damage the SCP-101 or
          the adapter.

          Always connect the DC adapter to the SCP-101 before you connect
          it to the power source. When you finish, disconnect the adapter
          from the power source before you disconnect it from the SCP-101.

Follow these steps to power the SCP-101 from DC power.

1.  If the adapter has a voltage switch, set the switch to 3V.

2.  Insert the Adaptaplug into the adapter's cord so it reads TIP +.

3.  Insert the Adaptaplug into the SCP-101's DC 3V jack.

    Note:  Connecting an adapter to the SCP-101's DC 3V jack disconnects
           the internal batteries.

4.  Plug the other end of the DC adapter into the vehicle's cigarette
    lighter socket.

Connecting Headphones/Speakers

To listen to the SCP-101, connect stereo headphones or amplifier speakers 
(neither supplied) equipped with a 1/8-inch (3.5 mm) stereo plug to 
PHONES.  Your local RadioShack store sells a wide variety of stereo 
headphones and amplified speakers.

Listening Safely

To protect your hearing, follow these guidelines when you use headphones.

  Set the volume to the lowest setting before you begin listening.  After
  you begin listening, adjust the volume to a comfortable level.

  Do not listen at extremely high volume levels.  Extended high-volume
  listening can lead to permanent hearing loss.

  Once you set the volume, do not increase it.  Over time you ears adapt
  to the volume level, so a volume level that does not cause discomfort
  might still damage your hearing.

Traffic Safety

Do not wear headphones while operating a motor vehicle or riding a 
bicycle.  This can cause a traffic hazard and could be illegal in some 
areas.

Even though some headphones are designed to let you hear outside sounds 
when you listen at normal volume levels, they still can present a traffic 
hazard.

Using the Belt Clip

For hands-free carrying, install the supplied belt clip.

To install the belt clip, place it below and between the two guides on the 
back of the player.  Then slide the clip in the opposite direction of the 
arrow until it snaps into place.

To remove the belt clip, lift the tab at the point marked LIFT, then slide 
the clip in the direction of the arrow.