MPS-50 50 Watt Speaker/Amplifier
(320-2046)                 Connections                Faxback Doc. # 56803

Input

Note:  You can connect audio equipment with a stereo or monaural plug.
       When you connect a stereo plug, the MPS-50 converts the stereo
       output to monaural.

Use a phone cable (available at your local RadioShack store) with a 1/4 
inch (6.35 mm) plug to connect an electric guitar, keyboard, or high 
impedance microphone to the HIGH input jack of Channel 1 and/or Channel 2.

Use a phone cable with a 1/4 inch (6.35 mm) plug to connect a low 
impedance (200-600 Ohms) microphone to the LOW jack of Channel 1 and/or 
Channel 2.

Output

To play the MPS-50's output signal through your sound system, connect one 
end of an audio patch cord (available at your local RadioShack store) with 
a 1/4 inch (6.35 mm) phone plug to the MPS-50's LINE OUT jack.  Then 
connect the other end to your amplifier/receiver/mixer's input jack.

Send and Return

To send the MPS-50's signal to a sound effect device, such as an echo 
reverb or digital sampler processor, connect a phone cable (available at 
your local RadioShack store) with a 1/4 inch (6.35 mm) phone plug to the 
MPS-50's SEND (output) jack, then connect the other end to the sound 
effect device's input jack.

To receive signal from the connected device, connect a phone cable with a 
1/4 inch (6.35 mm) plug to the MPS-50's RETURN jack, then connect the 
other end to the device's output jack.

Reverb Remote

You can connect an optional remote footswitch to the MPS-50's REVERB 
REMOTE jack and use the switch to control reverb effects.

Power

Note:  Before you connect the MPS-50 to AC power, set POWER to the off
       (out) position and MASTER to MIN.

Connect the female jack end of the supplied power cord to the AC jack on 
the back of the MPS-50, then connect the other end to a standard AC 
outlet.

(EB 9/21/99)